Versions Compared

Version Old Version 22 New Version Current
Changes made by

Anjali Tyagi

Anjali Tyagi

Saved on

Key

  • This line was added.
  • This line was removed.
  • Formatting was changed.

...

Code Block
languagebash
scsctl init dhcp --dhcp-reserve-lower 30
Info

Info

  • The configuration values used for DHCP reserve lower or upper range always come from the network planning.

  • If you are re-running scsctl init dhcp after initial install for any reason, it is recommended to check the bash history on the SCS to view the prior scsctl command and its settings. Run the below command on the SCS to view the last DHCP setting command used.

    Code Block
    history | grep "scsctl init dhcp" | tail -1

See https://perifery.atlassian.net/wiki/spaces/public/pages/1223491667/SCS+Administration#Swarm-(Internal)-Network-MTU to configure the MTU value that DHCP serves to storage nodes.

See https://perifery.atlassian.net/wiki/spaces/public/pages/1223491667/SCS+Administration#Swarm-(Internal)-Network-Gateway to configure the network gateway that DHCP serves to storage nodes.

Tip

Next, Power on the Swarm Storage Nodes Install Swarm License.