Preparing the Search Cluster
- Rumena Zlatkova (Deactivated)
- Anjali Tyagi
- Bala Harish A(AC)
- Kyle Miller (Deactivated)
Info
Always use a fresh server. New Elasticsearch install if performed on a server that has old Elasticsearch installations, does not update all the config files (https://caringo.atlassian.net/wiki/spaces/public/pages/2443809957/Configuring+Elasticsearch#Scripted-Configuration). Hence, some leftover config files remain not updated with the new Elasticsearch install.
Perform the following steps to prepare the search servers for Elasticsearch:
Verify the servers against the Hardware Requirements for Elasticsearch.
Appropriately cable the servers to your network infrastructure so they are reachable from the Swarm nodes.
Important
Make sure that Elasticsearch nodes are not accessible externally; only the Swarm nodes and Gateway servers should be able to access Elasticsearch.
Install RHEL/CentOS 7 or RHEL/Rocky Linux 8. System locale set to
LANG=en_US.UTF8and apply any required updates. Contact DataCore Support for questions about enabling or disabling IPv6.
Best Practice
Use RHEL/CentOS/Rocky Linux minimal server with compatibility libraries which is standard for Swarm development and testing. RHEL/CentOS desktop consumes extra resources that Elasticsearch uses and alters the OS configuration to emphasize user interface vs server performance. It also requires additional updating and security maintenance.
Configure the servers with static IP addresses.
Configure DNS, if desired.
Adjust the server firewall rules. See firewalld.org.
Adjust the rules to permit the following ports if on CentOS 7, install and runiptables:Allow public access on these ports:
firewall-cmd --permanent --zone=public --add-port=9200/tcp firewall-cmd --permanent --zone=public --add-port=9300/tcp firewall-cmd --reload
Related content
© DataCore Software Corporation. · https://www.datacore.com · All rights reserved.