Atlassian uses cookies to improve your browsing experience, perform analytics and research, and conduct advertising. Accept all cookies to indicate that you agree to our use of cookies on your device.

Atlassian cookies and tracking notice, (opens new window)

Atlassian uses cookies to improve your browsing experience, perform analytics and research, and conduct advertising. Accept all cookies to indicate that you agree to our use of cookies on your device. Atlassian cookies and tracking notice, (opens new window)

Swarm Documentation
Swarm Documentation
Troubleshooting articles
Troubleshooting articles
How-to articles
How-to articles

Results will update as you type.

Do I have to specify the retention days when I write data into Swarm or can I omit the retention days parameter?
Does the creation of a secondary DNS inside the network provide improvements?
EC Parameters in the Persistent Settings Stream in mixed Swarm pre-8.1
For "round robin" DNS usage, wouldn't a lower configured TTL (time-to-live) of 0 be preferable?
How do I get rsyslog to log timestamps and IP addresses from remote machines?
How do I prevent my disks from going idle?
How much memory is recommended in a Swarm node?
How much syslog space does Swarm use?
Health Usage Report (in Swarm 6.5.x and beyond)
Manually Updating the Swarm Health Report
How to USB boot Swarm nodes using web hosted license and configuration files
Can Swarm components run in VMware?
Changing Swarm admin password for Swarm 7.2 or higher
Which Virtual Machine platforms are supported for Swarm deployment?
How to Verify NTP Information on Swarm Nodes
Symantec/Veritas Enterprise Vault Swarm/CAStor integration
What is cip.histogramTolerance?
How to look at the Replication feed FEEDs info line- feed causes
How do I fix trapped space?
How do I know if defragmentation is going on?
What OS does Swarm use?
How to check and change healthExamDelay
Is a VLAN needed between the cluster nodes or is the fact that the cluster is behind a switch enough?
Is it necessary to configure "round-robin" DNS in the Primary DNS or can a secondary DNS be utilized?
Is it possible to specify different configuration parameters for different nodes when netbooting?
miimon bonding parameter
Multiple processes per physical Swarm node
"Not enough information to estimate license space" error
Are retiring nodes' streams counted when performing a countreps for a stream
Can I reboot a single process in a multi-process Swarm node?
Confirming Current Licensed capacity for Swarm CSN Dell DX
Does Swarm allow lifepoint policy updates for content after the content has been stored in Swarm?
FEEDS INFO - feed queue is full
How can I clear the errors and announcements from all of my nodes?
How can I validate that the streams I am sending to Swarm are being received?
How to update the cluster's Technical Contact
How do I collect the hardware MIB (non Caringo values) for net-snmp?
How do I configure rsyslog server to accept incoming syslog messages from Swarm products?
How do I disable the health status reports (phone home)
How do I find out how many processors are available on my running Swarm node?
How do I find out my disk controller/ driver version?
What is needed to create a solution that has no single point of failure?
How is Swarm protected from network attacks from worms, trojan horses or viruses?
Is there a CLI interface from which to gather statistics?
How does a Swarm system handle a UPS event?
In a complete Swarm chassis failure scenario, what is the process for replacing it?
How is the health of Swarm monitored?
Is there an easy way to monitor streams to gauge when hard drive space is becoming scarce?
Is replacing a failed hard disk as simple as turning off a node, swapping in a new disk and restarting the node?
Node fails to boot- node has a media card reader
Node fails to boot- NTP
SNMP Traps in Swarm
Large files in Swarm
Used capacity vs Licensed capacity in Swarm
I/O errors and Swarm nodes
Stale Volumes and the ":k" flag
Network Traffic in a Cluster
Missing debug level logs
Protect the Swarm admin console with username/ password
Unretire all
Troubleshooting a spike in disk failures or retires
I deleted my persistent settings stream that contained my domains!
Stream count does not seem right after reboot
Can I Add Capacity to My Existing License?
Is training available for Swarm?
Maintenance mode
Persistent Settings Stream (PSS)
_forgetDelete error - journaled
How do I manually write an EC stream?
Integrity Check Failures
How do I tcpdump to capture only HEAD traffic?
How much syslog space does CAStor use?
How many replicas do I get with minreps=1 and Replicate on Write (ROW)?
How does network bandwidth impact Swarm operations?
How does retire work?
How does Swarm handle interrupted transfers (abandoned uploads)?
How is a node chosen in a Swarm cluster when Read/ Write requests are sent from the application?
Example "curl" commands for uploading files to Swarm Content Gateway
How do I list the UUIDs on a volume?
How do I prevent my newly added disks from getting overwhelmed by replicas from existing streams?
How is content referenced in Swarm?

You‘re viewing this with anonymous access, so some content might be blocked.

/

How do I find out my disk controller/ driver version?

Updated Jun 29, 2017

How do I find out my disk controller/ driver version?

Jun 29, 2017

Boot your CAStor node temporarily into another linux version (using a Live CD for example), and type:

lspci -k

© DataCore Software Corporation. · https://www.datacore.com · All rights reserved.

{"serverDuration": 38, "requestCorrelationId": "f4d1ebdb6ac24283a4bcb2fa28ac8df9"}