Changes in Swarm Cluster Installer (SCI) 2.4

Changes in Swarm Cluster Installer (SCI) 2.3

Changes in Swarm Cluster Installer (SCI) 2.3

Improvements

This release features the following improvements:

• Includes Swarm Storage 15.0.1

Limitations

• Same as earlier

Changes in Swarm Cluster Installer (SCI) 2.2

Changes in Swarm Cluster Installer (SCI) 2.2

Improvements

This release features the following improvements:

• Swarm Storage may run without multicast for inter-node communication. The default SCI 2.2 is set to not use multicast for both new installations and upgrades. This default is preferred for new installations. Any existing Swarm cluster installation has multicast enabled. Changing this setting between values requires a full (non-rolling) reboot of the entire cluster during storage upgrade. If an organization requires rolling reboots to avoid downtime, restore the legacy setting after upgrading SCI, but before rebooting any Swarm Storage nodes.
  Run the following command on the SCS node:
  scsctl storage config set -d "cip.multicastEnabled=true"
  Once the command runs successfuly, use a rolling reboot to upgrade to the new Swarm storage software.

Limitations

• GUI-based upgrade functions well when the cluster is installed using SCI 2.x, with no manual changes in the configuration files (for example, gateway.cfg and elasticsearch.yml). However, this upgrade inherits the changes of SCS, storage, and gateway done through Content Portal and Swarm UI.

Changes in Swarm Cluster Installer (SCI) 2.1

Changes in Swarm Cluster Installer (SCI) 2.1

Improvements

This release features the following improvements:

• Cluster Upgrades: SCI 2.1 provides GUI-based cluster upgrades for all the components including SCS, gateway, Elasticsearch, Prometheus, and Grafana.

• Data Disks: Separate data disks for Elasticsearch datastore as well as Prometheus and Grafana.

Limitations

• GUI-based upgrade functions well when the cluster is installed using SCI 2.0 with no manual changes in the configuration files (e.g., 'gateway.cfg' and ‘elasticsearch.yml’). However, this upgrade inherits the changes of SCS, storage, and gateway done through UIC/UIS.

Changes in Swarm Cluster Installer (SCI) 2.0

Changes in Swarm Cluster Installer (SCI) 2.0

Improvements

This release features the following improvements:

• UI-Based Installation: The SCI 2.0 is a UI-based solution for automatic installation and configuring the Swarm ecosystem on VMware vCenter.

• Simplified Deployment: No complex CLI commands or steps are required as SCI 2.0 provides an ability to generate configurations based on the expected workload.

• Simplified Data Protection Solution: Bucket lifecycle policies allow a bucket owner to use versions without worrying about the manual cleanup of old versions. This data protection mechanism mitigates concerns about runaway cluster space usage by limiting version accumulation.

Limitations

• SCI 2.0 UI-based installation is performed in the VMware vCenter environment.

• Bucket Lifecycle Policy installation supports Gateway 7.9, Content Portal 7.6, and Swarm Storage 14.1 versions.