...
Create a node.cfg file and add any node-specific Swarm settings to apply, or leave it blank to accept all current settings.
Power on the chassis for the first time.
Wait until the chassis enlists and powers off.
Deploy the new server:
Code Block language bash platform deploy storage -n 1 -v <#.#.#-version-to-deploy>
To Use the following process to deploy an individual chassis by system ID, use this process:
Create a node.cfg file and add any node-specific Swarm settings to apply , or leave it blank to accept all current settings.
Get a list of chassis that are available for deployment by using the following command:
Code Block language bash platform list nodes --state New
Choose a System ID to deploy a single chassis using a command like the following:
Code Block language bash platform deploy storage -y 4y3h7p -v 9.2.1
Service Proxy
If Restart the service so it picks up the new chassis list if the Service Proxy is running on the Platform Server when adding or removing chassis, restart the service so it can pick up the new chassis list:
| Code Block | ||
|---|---|---|
| ||
platform restart proxy |
...
The CLI parses the uploaded configuration file for changes to make to Platform.
If Swarm was running during the upload, Platform Server attempts to communicate the new configuration to Swarm if Swarm was running during the upload. Any settings that cannot be communicated to Swarm requires a reboot of the Swarm cluster in order to take effect. For each setting contained in the file, the The CLI indicates if the setting was communicated to the Storage cluster and if a reboot is required for each setting contained in the file. The Swarm UI also indicates which settings require rebooting.
...
Permanent removal — Permanent removal is for retiring a chassis altogether or changing the chassis' main identifying information, such as changing a NIC. Removing the chassis from management causes the chassis to start the provisioning life cycle as if it were is a brand new chassis, if it is powered on again.
...