This release features the following improvements: Any special configuration is no longer required on the switch due to multicast being disabled by default between storage nodes. Enabling multicast is allowed via SCS CLI after the installation is done. However, As of v15.0, Swarm Storage may be run without the use of multicast for inter-node communication. SCI 2.2 will default to not use multicast for both new installations and upgrades. This default is preferred for new installations. Any existing Swarm cluster installation would have multicast enabled. Changing this setting between values requires a full (non-rolling) reboot of the entire cluster is required after the SCI , which can be done at the same time as a storage upgrade. If your organization instead requires rolling reboots to avoid downtime, then please run the following command the legacy setting should be restored after SCI has been updatedupgrade, but before rebooting any Swarm Storage nodes. Run the following command on the SCS node:
scsctl storage config set -d "cip.multicastEnabled=true"
Once this has been run, a rolling reboot may be safely used to upgrade to the new Swarm Storage software.
LimitationsGUI-based upgrade functions well when the cluster is installed using SCI 2.x, with no manual changes in the configuration files (for example, gateway.cfg and elasticsearch.yml). However, this upgrade inherits the changes of SCS, storage, and gateway done through Content Portal and Swarm UI.
| 