Versions Compared

Version Old Version 8 New Version 9
Changes made by

Kyle Miller (Deactivated)

Kyle Miller (Deactivated)

Saved on

Key

  • This line was added.
  • This line was removed.
  • Formatting was changed.

...

Info

Requirements

Before a rolling reboot can begin, these conditions must be met:

  1. All chassis targeted for rebooting must be running and reachable. If you have offline chassis, be sure to set a flag to have them ignored:

    • To skip the connection check altogether, add the flag --skipConnectionTest

    • To have the reboot process ignore currently offline chassis, add the flag --continueWithOfflineChassis

  2. All chassis must have an uptime greater than 30 minutes. To skip this requirement, add the flag --skipUptimeTest

...

You have 10 seconds to cancel a rolling reboot before it begins. Once a rolling reboot has started, it will stop stops and report reports an error if any of these the following occur:

  1. A chassis is offline when it is selected for reboot. To have the reboot process ignore currently offline chassis, add the flag --continueWithOfflineChassis.

  2. The reboot process will continue if the volumes come up but a node goes into an error state. To have the reboot process stop, add the flag --stopOnNodeError.

  3. If the chassis boots with a number of volumes that doesn't match the number present before the chassis was rebooted. A volume is considered up if it has a state of: ok, retiring, retired, or unavailable

  4. The chassis does not come back online after 3 hours has passed.

...