| Table of Contents |
|---|
...
Managed switches may implement IGMP snooping to direct multicast traffic to ports. The purpose of IGMP snooping is to block unnecessary multicast traffic from hosts who are not interested in the traffic. The switch will only forward forwards multicast traffic out to ports where it heard an IGMP join message within a configurable time (typically around 5 minutes).
Swarm nodes are recommended to exist in a separate private VLAN so there are no other hosts in the broadcast domain. Disable IGMP snooping from the Swarm nodes' VLAN because there is no benefit to having IGMP snooping configured in a VLAN that only includes solely including Swarm products.
Configure an IGMP querier for your cluster's multicast group(s) f you cannot disable IGMP snooping from the VLAN.
...
When a Swarm node joins a cluster, it sends an initial set of unsolicited join requests for its the configured multicast group. At that point, all Swarm nodes are visible from the Swarm Admin Console of all other nodes. IGMP queriers periodically send another query to see if there are any hosts still interested in the multicast group. As required by the IGMP RFCs, Swarm nodes will do not send addition unsolicited join requests. If there is no querier for that multicast group in the network, the switch will stop stops forwarding multicast traffic for that particular group out of that particular switch port when the switch timer for that multicast group runs out. After the timeout, all Swarm nodes appear to be unable to contact each other because the router did not send a query to prompt a subsequent join by the Swarm node.
Some switches are configured to act as IGMP queriers in an IPv4 network for multicast group memberships, but other switches are not unless configured appropriately. Since multicast routing is not configured by default on all switches, an IGMP querier may not exist on your network unless you have specifically configured one.
If you do not have a querier available in your network, the Swarm can be configured to perform this function . When configured to do so, Swarm will elect if a querier is not available in the network. Swarm elects a node in the cluster to act as an IGMP querier , ensuring that when configured to do so, guaranteeing multicast membership queries are sent so cluster operation can continue. The Swarm IGMP querier will have has no impact on networks that do not have IGMP Snooping enabled.
To enable an IGMP querier on the Swarm cluster itself, set it via the SNMP MIB entry networkIGMPTimeout and enable the network.igmpTimeout configuration parameter in Swarm.
...
To help identify cluster networks where IGMP snooping is enabled without an IGMP querier, a node will log logs a critical error on the Swarm Admin Console and in the syslog, recommending administrators check for the presence of IGMP snooping. The node does this when these conditions occur:
...
By default, Swarm uses IGMPv2 responses to host membership queries. The igmpVersion parameter can be used to force the use of version 1, 2, or 3.